Spare Switches For Pol03

Features

• Genuine Tork Craft spare switches for the POL03 polisher.
• Matched to the original switch layout and rating used on the tool.
• Designed to fit directly into the POL03 handle and housing.
• Positive switching action for clear on/off feedback.
• Suitable for busy panel shops, detailing bays and workshops.
• Ideal as a service part to keep POL03 machines in daily use.

Benefits

• Restores reliable starting and stopping on a tired or faulty POL03.
• Improves safety by replacing worn, sticky or intermittent switches.
• Reduces nuisance cut-outs that interrupt polishing work.
• Extends the working life of the polisher instead of replacing the whole machine.
• Correct OEM parts make future servicing and fault-finding easier.

Extra Information

Typical signs that the POL03 switches are due for replacement include a polisher that only runs when the switch is held in a certain position, fails to start occasionally, crackles when switched, or does not switch off cleanly. Replacing the worn switches with the POL03-05 spare set is often all that is needed to restore dependable control.

When working in the switch area, it is a good opportunity to inspect the mains cable, strain relief and internal wiring at the same time. Combining a fresh switch set with sound cabling helps ensure long-term reliability and safety in professional and home workshops.

Pro Tip

Pro Tip: Before removing the old switches, take clear photos of the wiring layout inside the POL03 handle. After fitting the new POL03-05 spare switches, double-check every connection and cable route before closing the housing, then test the polisher under no load to make sure it starts and stops crisply without hesitation.

Specifications

Safety

• Always disconnect the polisher from the mains before opening the housing or working on the switches.
• Allow the tool to cool down fully before handling internal components.
• Ensure all electrical connections are secure, insulated and correctly routed after fitting the new switches.
• Refit all covers, guards and screws securely and test the polisher under no load before normal use.
• If you are unsure about electrical repairs, use a qualified technician or an approved service centre.