Polisher S/kit Capacitor & Induct (41/42) For Pol02

Features

• Genuine Tork Craft service kit for the POL02 wool bonnet polisher.
• Includes capacitor and inductor components corresponding to items 41 and 42.
• Matched to the original POL02 electrical specification and rating.
• Helps reduce electrical noise and interference on the supply.
• Supports smooth, predictable motor response during start-up and use.
• Designed for continuous polishing work in workshop and detailing environments.

Benefits

• Restores correct electrical behaviour on a tired or repaired POL02 polisher.
• Can help reduce nuisance tripping and electrical “buzz” or interference.
• Supports longer motor life by maintaining proper operating conditions.
• Ensures compliance with the original design rather than using generic components.
• Genuine matched parts simplify troubleshooting and future servicing.

Extra Information

Typical signs that the capacitor or inductor may need attention include unusual humming, a strong smell from the electrical area, visible swelling or cracking on the capacitor body, or a polisher that behaves erratically despite good brushes and wiring. Replacing these parts with the POL02-SK12 kit ensures the electrical filtering and support circuit is brought back in line with factory specification.

When working on the electrical section of the POL02, it is good practice to inspect the switch, cable, strain relief and internal connections at the same time. Combining these routine checks with genuine Tork Craft spares helps keep your wool bonnet polisher reliable and workshop-friendly on the power supply.

Pro Tip

Pro Tip: Always make a clear note or take a photo of the wiring layout before removing the old capacitor and inductor. After fitting the new POL02-SK12 components, double-check each connection against the original layout and ensure no wires are pinched when closing the housing. Test the tool at low speed under no load first and listen for smooth, steady running before returning it to full-duty work.

Specifications

Safety

• Always disconnect the polisher from the mains before opening the housing or touching internal wiring.
• Allow capacitors time to discharge and handle components carefully.
• Ensure all connections are secure, insulated and routed correctly after fitting.
• Refit all covers, guards and screws properly before testing the machine.
• If you are unsure about electrical repairs, use a qualified technician or an approved service centre.