Polisher Service Kit Cord Clamp & Sleeve (33/41/43) For Pol05

Features

• Genuine Tork Craft cord clamp and sleeve kit for the POL05 polisher.
• Includes clamp, sleeve and related cord support components (items 33, 41, 43).
• Provides proper strain relief where the power cord enters the rear housing.
• Flexible sleeve helps prevent tight bends and kinks in the cable jacket.
• Clamp design matches the original POL05 handle moulding and screw pattern.
• Durable materials designed for workshop use and repeated cable movement.

Benefits

• Helps prevent internal cable breaks at the tool entry point.
• Reduces the risk of exposed conductors and unsafe cable damage.
• Keeps the cord routing neat and controlled at the rear of the polisher.
• Improves tool longevity by protecting the mains lead during daily use.
• Restores a professional, “factory finish” appearance to the cable exit area.

Extra Information

Common signs that the cord clamp and sleeve need replacement include a cable that can slide in and out of the handle, visible cracking or splitting of the rubber boot, or a section of cable insulation that looks pinched or white where it repeatedly bends. Running the machine in this condition can eventually lead to internal wire breaks or dangerous live spots.

The POL05-SK15 kit is designed specifically for the Tork Craft POL05, so the clamp profile, sleeve length and locating features all match the original housing. Using the correct cord support parts ensures the cable is held firmly without being crushed, and gives the rear of the tool a tidy, professional look again.

Pro Tip

Pro Tip: When fitting the POL05-SK15 cord clamp and sleeve, inspect the mains cable carefully for cuts, flat spots or broken outer insulation near the entry point. If the cable shows damage, replace the complete lead rather than just the clamp. Position the new sleeve so the first bend in the cord happens in the flexible section, then tighten the clamp screws evenly so the cord is held securely without being overly squashed.

Specifications

Safety

• Always unplug the polisher from the mains before working on the power cord or clamp.
• Do not reuse a cable with damaged insulation or exposed conductors – replace it completely.
• Ensure the new clamp and sleeve are correctly positioned and fully secured before use.
• After assembly, flex the cord gently near the entry point and check that it remains firmly held with no movement inside the housing.
• Do not operate the polisher if you can see the inner wires at any point along the cable.
• If you are unsure about electrical safety or repairs, have the work carried out by a qualified technician or an approved service centre.