Polisher Bearing Holder For Pol04

Features

• Genuine Tork Craft bearing holder for the POL04 rotary polisher.
• Matched to the original POL04 housing and bearing dimensions.
• Accurately locates the bearing to keep shafts running true.
• Supports the drive system under continuous polishing loads.
• Heat-resistant construction for workshop and detailing environments.
• Direct replacement spare referenced as POL04-34.

Benefits

• Helps reduce vibration and noise caused by misaligned bearings.
• Improves backing pad stability for a smoother, more even finish.
• Protects gears, shafts and housings from stress due to poor support.
• Extends the service life of the POL04 instead of replacing the whole tool.
• Using the correct OEM holder simplifies future servicing and diagnostics.

Extra Information

Typical signs that the bearing holder may need replacement include visible cracking, distortion or wear around the bearing seat, bearings that fit loosely, or a spindle that shows side play even after new bearings are fitted. In these cases, replacing only the bearing is often not enough – the carrier that holds it also needs to be brought back to factory condition.

The POL04-34 bearing holder is designed specifically for the Tork Craft POL04 rotary polisher so that the bearing sits at the correct depth and alignment in the housing. Combining a fresh holder with genuine bearings and proper lubrication helps keep the drive assembly running quietly and reliably for day-to-day professional use.

Pro Tip

Pro Tip: Whenever you remove a bearing from the housing, inspect the holder closely for hairline cracks, heat marks or oval-shaped wear. If the bearing does not press in with a firm, even fit, replace the holder with the POL04-34 spare before reassembling the polisher and running it at speed.

Specifications

Safety

• Always unplug the polisher from the mains before opening the housing or working on bearings and supports.
• Allow the tool to cool down fully before handling internal components.
• Ensure the bearing is correctly seated in the new holder and the holder is properly positioned in the housing.
• Refit all covers, guards and screws securely and test the polisher under no load before normal use.
• If you are unsure about mechanical repairs, have the work done by a qualified technician or an approved service centre.