Carbon Brush Holder For Pol03

Features

• Genuine Tork Craft carbon brush holder for the POL03 polisher.
• Matched to the original POL03 motor brush layout and sizing.
• Guides the carbon brush for smooth in-and-out movement.
• Helps maintain consistent spring pressure on the commutator.
• Heat-resistant construction for workshop and professional use.
• Designed to work with genuine Tork Craft carbon brushes for the POL03.

Benefits

• Helps restore stable electrical contact between brush and commutator.
• Reduces the risk of brushes sticking, chattering or wearing unevenly.
• Supports smoother running and less excessive sparking from the motor.
• Extends the life of both the brushes and the commutator surface.
• Using the correct OEM holder simplifies future servicing and fault-finding.

Extra Information

Typical signs that a brush holder may need replacement include brushes that do not slide freely, signs of melting or discolouration around the holder, loose or broken retaining clips, or a polisher that runs erratically even with new brushes fitted. Replacing a damaged holder with the POL03-16 spare brings the brush system back in line with the original factory design.

When working in the brush area on a POL03 polisher, it is sensible to inspect the brushes themselves, the commutator surface, cable and switch at the same time. Combining fresh holders with genuine brushes and a clean commutator helps keep the machine reliable in both professional and home workshops.

Pro Tip

Pro Tip: Before fitting a new brush holder, carefully clean out any old carbon dust and debris from the motor housing and brush cavity. After installing the holder and new brushes, run the POL03 at low speed with no load for a short period to let the brushes bed in properly against the commutator and to check for smooth, even motor noise.

Specifications

Safety

• Always disconnect the polisher from the mains before opening the housing or working on the brush system.
• Allow the tool to cool down fully before handling internal components.
• Ensure brushes move freely in the new holder and that springs are seated correctly.
• Refit all covers, guards and screws securely before testing the polisher.
• If you are unsure about electrical repairs, use a qualified technician or an approved service centre.