Polisher Service Kit Armature Rear Bearing & Holder For Pol05

Features

• Genuine Tork Craft armature rear bearing and holder kit for the POL05 polisher.
• Includes rear bearing and dedicated holder matched to the POL05 motor housing.
• Correct internal and external dimensions for the original armature shaft and seat.
• Bearing holder keeps the bearing square and firmly located in the rear housing.
• Helps maintain accurate armature alignment through the full speed range.
• Designed for daily duty in panel shops, body repair centres and detailing bays.

Benefits

• Reduces motor noise, harshness and vibration from a worn rear support.
• Helps the armature run true, protecting brushes, commutator and front bearings.
• Improves overall balance and comfort when polishing for long periods.
• Prevents the bearing from spinning or fretting in a damaged holder.
• Extends the service life of the POL05 instead of replacing the complete tool.
• Convenient kit format ensures both bearing and holder are renewed together.

Extra Information

Typical signs that the rear bearing and holder need attention include a humming or rumbling noise from the handle end of the tool, a “loose” feel when you start or stop the polisher, visible play when you move the armature by hand, or signs that the old bearing has overheated and marked the holder. If the bearing has spun in the housing, the plastic or metal of the holder can be damaged and must be replaced together with the bearing.

The POL05-SK07 kit is specified for the Tork Craft POL05, so the bearing size, holder profile and locating points all match the original design. Using genuine rear support parts helps the motor run as intended and pairs well with fresh brushes and a clean commutator when carrying out a full motor service.

Pro Tip

Pro Tip: When fitting the POL05-SK07 armature rear bearing and holder, inspect the armature shaft where the bearing runs. If there are deep grooves, heat marks or rough spots, polish them lightly or replace the armature to avoid damaging the new bearing. Press the bearing into the holder using the correct tools, seat the assembly squarely in the housing and always test the motor at low speed with no load before returning the polisher to full-duty work.

Specifications

Safety

• Always unplug the polisher from the mains before opening the housing or working on the motor.
• Allow the tool to cool down fully before handling bearings, holders and windings.
• Use suitable pullers and press tools when removing and fitting bearings – do not hammer directly on the shaft or bearing.
• Ensure the new bearing holder is fully seated and all screws are tightened securely before testing.
• Test the POL05 under no load after reassembly and stop immediately if you hear unusual noises or feel excessive vibration.
• If you are unsure about mechanical or electrical repairs, have the work carried out by a qualified technician or an approved service centre.