Repl. Armature & Magnetic Ring (22/28/29/30) Service Kit

Features

• Motor drivetrain service kit: Replaces the armature and magnetic ring component group for the TCAG0115.
• Parts reference match: Covers parts 22, 28, 29 and 30 as per the service diagram references.
• Restores motor smoothness: Helps correct rough running caused by worn or damaged motor internals.
• Model-specific compatibility: Intended for the Tork Craft TCAG0115 115mm angle grinder platform.

Benefits

• Bring back power and stability: Helps restore consistent performance under load for grinding, cutting and clean-ups.
• Reduce harshness and sparking: Fresh motor components can improve running smoothness and reduce stress on brushes and commutation.
• Extend tool life: A proper motor rebuild can protect related parts and delay full tool replacement.

Extra Information

• Compatibility: Intended for the Tork Craft TCAG0115 angle grinder (115mm, 900W, 11 000 RPM, 220V).
• Recommended: When replacing an armature, inspect/replace carbon brushes and check bearings for play or noise.
• Workshop tip: Clean out carbon dust and debris during assembly to improve reliability and reduce premature wear.

Specifications

Safety

• Wear eye, ear and dust protection when operating an angle grinder.
• Disconnect power before opening the tool or fitting any spare parts.
• Motor repairs should be done by a competent technician—incorrect assembly can cause electrical shock or mechanical failure.
• After reassembly, confirm the guard is correctly fitted and the spindle rotates freely before use.
• Perform a no-load test run in a safe area after the repair and stop immediately if you hear rubbing, arcing, or severe vibration.