Repl. Cord & Clamp Set (48/49/54/55) Service Kit

Features

• Complete cord support kit: Replaces the power cord and the clamp/strain relief component group.
• Parts reference match: Covers parts 48, 49, 54 and 55 as per the service diagram references.
• Improves cable retention: Restores proper cord clamping to reduce internal wire fatigue and terminal stress.
• Model-specific compatibility: Intended for use with the Tork Craft TCAG0115 angle grinder.

Benefits

• Safer operation: Replacing damaged cords reduces the risk of electric shock, short circuits and overheating.
• Eliminates intermittent cut-outs: Fresh wiring and proper strain relief help stop “runs only when you wiggle the cord” problems.
• Longer-lasting repair: Correct clamping protects internal connections and helps prevent repeat failures.

Extra Information

• Compatibility: Intended for the Tork Craft TCAG0115 angle grinder series.
• If the tool trips a breaker or shocks, stop using it immediately and have it inspected by a qualified technician.
• During replacement, inspect the switch terminals and internal wiring for heat damage or looseness.
• Ensure the cord is routed correctly and the clamp/strain relief is fitted snugly to prevent internal movement.

Specifications

Safety

• Wear eye protection when opening housings and working near springs and fasteners.
• Disconnect power before opening the tool or fitting any electrical spare parts.
• Damaged cords are a shock hazard — never tape over severe insulation damage; replace correctly.
• Electrical repairs should be completed by a competent technician; incorrect wiring can cause electric shock or fire.
• After repair, perform a no-load test run in a safe area and stop immediately if you smell burning, see arcing, or the tool behaves erratically.