Output Shaft & Big Gear Compl. Kit (5-11/15) S/kit

Features

• Designed for TCID0850 Correct-fit service kit for the Tork Craft TCID0850 impact driver gearbox section.
• Output shaft & big gear complete Covers parts 5–11 and 15 as referenced on the parts diagram.
• Restores gearbox engagement Ideal for replacing worn or damaged gearing that causes slipping or rough running.
• Workshop-ready repair solution A practical kit for refurbishing a hardworking impact driver instead of replacing the whole tool.

Benefits

• Bring back torque delivery: Fresh drive components help restore strong, consistent fastening performance.
• Reduced grinding and noise: Replacing worn gears can improve smoothness and reduce unpleasant gearbox sounds.
• Less play at the output: Helps tighten up the drive feel and improve control under load.
• Extend tool life: A drive train rebuild can keep your TCID0850 working reliably for longer.

Extra Information

• Compatible tool: Tork Craft TCID0850 Impact Driver.
• This is a service kit—confirm parts 5–11 and 15 against your TCID0850 parts diagram before ordering.
• During installation, clean out old grease and debris, then re-grease the gearbox with a suitable gear grease for best results.

Specifications

Safety

• Disconnect the tool from the power source (battery/mains) before opening the gearbox housing or replacing internal parts.
• Wear eye protection and keep small parts organised during disassembly and reassembly.
• Ensure gears are correctly seated and the gearbox is fully secured before operating the tool.
• Test-run the tool briefly with no load after reassembly to confirm smooth operation.