Brush Holder (52/54) For Tccs0185

Features

• Brush support component kit: Replaces the brush holder components that guide and support the carbon brushes.
• Parts reference match: Covers parts 52 and 54 as per the service diagram references.
• Improves brush seating: Helps maintain correct alignment for proper commutation.
• Model-specific compatibility: Intended for use with the Tork Craft TCCS0185 cut-off saw.

Benefits

• More reliable running: Consistent brush contact helps reduce cutting-out and intermittent power.
• Reduced arcing and wear: Correct alignment can lower excessive sparking and slow commutator wear.
• Better servicing results: Ideal when cracked or loose holders make a simple brush replacement ineffective.

Extra Information

• Compatibility: Intended for the Tork Craft TCCS0185 cut-off saw series.
• Recommended: Inspect/replace the carbon brushes at the same time if they are near wear limits.
• Check the commutator: Heavy burning, pitting or deep grooves may indicate the armature needs attention.
• Keep it clean: Carbon dust build-up can cause tracking and poor electrical contact — clean carefully during service.

Specifications

Safety

• Wear eye protection and a dust mask when working with carbon dust and internal debris.
• Disconnect power before opening the tool or fitting any spare parts.
• Ensure holders, springs and wiring are seated correctly — misalignment can cause sparking, overheating or motor failure.
• After reassembly, confirm the guard is correctly fitted and the spindle rotates freely before use.
• Perform a brief no-load test in a safe area and stop immediately if you see heavy arcing, smell burning or hear abnormal rubbing.