Polisher Service Kit Armature Front Bearing & Screws (12/22-24) For Po

Features

• Genuine Tork Craft armature front bearing and screw kit for the POL05 polisher.
• Covers front motor support components referenced as items 12 and 22–24.
• High-quality bearing for smooth, low-friction support at the gear box end.
• Matched screws and fixings to secure the bearing and related hardware.
• Designed specifically around the original POL05 motor and housing layout.
• Suitable for regular professional use in panel shops and detailing bays.

Benefits

• Reduces rumbling, grinding and front-end vibration from a worn bearing.
• Helps the backing pad run truer for a more consistent polishing finish.
• Protects gears, housings and the armature from misalignment and excess movement.
• Restores a solid, professional feel at the front of the machine.
• Extends the working life of the POL05 instead of replacing the complete tool.
• Convenient kit format saves time when servicing the front motor support.

Extra Information

Typical signs that the armature front bearing and its fixings need attention include distinct noise from the gear end of the tool, a rough or “gritty” feel when you spin the spindle by hand, visible play at the pad when you rock it sideways, or signs that the bearing has overheated. Running the polisher in this condition can quickly damage gears, shafts and housings.

The POL05-SK05 kit uses genuine Tork Craft components sized and specified for the POL05 motor. That means the bearing fits the housing and shaft correctly, and the screws are the right length and thread to clamp everything securely without risking stripped threads or distorted seats – essential for a long-lasting repair on a hard-working polisher.

Pro Tip

Pro Tip: When replacing the armature front bearing with the POL05-SK05 kit, always support the correct race when pressing the bearing on or off – inner race when working on the shaft, outer race when working in the housing. Clean away old grease and debris, lightly pack the new bearing and tighten the supplied screws evenly. After reassembly, run the POL05 at low speed with no load and listen for a smooth, even note before putting it back into full-duty service.

Specifications

Safety

• Always unplug the polisher from the mains before opening the housing or working on the motor.
• Allow the tool to cool down fully before handling internal components and bearings.
• Use suitable pullers and press tools when removing and installing bearings – do not hammer directly on the shaft or bearing races.
• Ensure all screws from the POL05-SK05 kit are correctly seated and tightened before testing.
• Test the POL05 under no load after reassembly and stop immediately if you hear unusual noises.
• If you are unsure about mechanical or electrical repairs, have the work carried out by a qualified technician or an approved service centre.